Recent content by Scubafill

  1. S

    Lowrance Global Nav 310 Aerial

    The wire between my Global Nav 310 and the aerial has been damaged near the aerial. The aerial is a sealed unit ( about 4" dia and 1" deep). A replacement aerial will be about £150 !!!!! Does anybody know how to open the sealed unit? Can I replacew the aerial wire? What sort of wire must...
  2. S

    Outboard Engine 2 Cycle Oil

    I am responsible for the dive club RIB which has a 200hp Mercury outboard. Since new we have used Quicksilver 2 cycle oil in the fuel injection system. I understand that the specification is TC-W3. I currently pay about £25.25p for 4 liters. Are there any cheaper alternative oils? I can only...
  3. S

    Engine Alarm

    Ian Its a Yanmar 1GM10 in a Hunter 26. I seem to remember that the alarm sounded when I turned the key on till the engin was started. Old age setting in - perhaps it did only sound for a short time. Phil
  4. S

    Repair to Asymmetrical Sail

    TigaWave Thanks for the rapid reply - if the sun stays out I will try and get some tape and repair today. Longer term I will sweet talk SWMBO to sew on a patch. Any idea what material I should use as a patch, sorry I don't know what material the sail is made from. It came with the boat and I...
  5. S

    Repair to Asymmetrical Sail

    My Asymmetrical sail is made from a very light material and has a couple of very small holes in the foot where it has caught on a bolt thread on the pullpit. Any ideas on how these should be repaired? Phil
  6. S

    Engine Alarm

    The alarm within my engine switch only sounds for about 5 seconds when I choke the engine or leave it switched on without starting the engine. Any comments or suggestions apreciated. Phil
  7. S

    Yanmar 1GM10 water pump kit

    Anybody else oout there know of a discounted water pump service kit supplier ? Phil
  8. S

    Yanmar 1GM10 water pump kit

    Steve28 found an ideal supplier in Brookfield Precision Engineering. Unfortunatly I contacted them today to order the kit, unfortunatly thay have had such little interest that it was not cost effective to buy in the parts to make up a kit. Apparently our call was the first one in 7 months! Oh...
  9. S

    Yanmar 1GM10 Water Pump leak

    Fastjedi Appologies for not using your name in the previous mail. I have done the same ie ordered the two lip seals and a cover gasket. I have been quoted £45 for a replacement shaft (ouch) so if the shaft is scored when I remove the pump or the bearings are shot I will consider a replacement...
  10. S

    Yanmar 1GM10 Water Pump leak

    Woof I use a local company Felton Marine Engineering based in Sovereign Marina at Eastbourne. 01323 470211. Not the cheapest around but he provides a good service and usally supplies parts not in stock within a couple of days. I think they get the parts from Barrus, the main agents...
  11. S

    Yanmar 1GM10 Water Pump leak

    There is no gasket between the block and the pump caseing just an O ring. Phil
  12. S

    Yanmar 1GM10 Water Pump leak

    Thanks guys Off to my local Yanmar dealer to order a service kit Phil
  13. S

    Yanmar 1GM10 Water Pump leak

    Gents, once again I am looking for advice from the broad band of knowlage out there. The water pump on my Yanmar 1GM10 has a very slight leak when the engine is running. From the forum, I know is a problem as other owners have reported that the sea water drips on the oil pipe and corrodes it...
  14. S

    advice pls: how to remove decortive lines round hull?

    I removed the sun damaged stripes from my 1990 Hunter 26 while on the hard a couple of weeks ago. Used SWMBO hairdryer and a very sharp scraper. With a bit of practice you can get the temp just right so that the stripe comes away and folds like a fan on the scraper. As the old stripe cools...
  15. S

    Hull stripes

    Pro-Boat have loads of PSB marine tapes in their brochure. Check out their website www.proboat.co.uk They may not supply direct as they are wholesalers but they will advise you of an outlet who stockes marine tapes. They seem to have a very good reputation on this forum. Phil
Top