Thanks for the Rebly and suggestions Vics I will run the engine and test the Alternator meter supply from the altmtr....The battery sensing is OK as I have seperate OK guages which both show 25v more or less its just the stbd alternator gauge, showing high (35V)
Regards and thanks Rob
This alternator has been taken off and checked out and found OK, and refitted for the very same fault, and proclaimed OK? but the 35volts are still being shown on the designated guage? anybody think or another reason why this might be happening faulty earth to the guage etc?? any suggestions...
Any electronics bodies out there who know what the Ohm range of a dual position (I think, as I never use the upper helm position) VDO rudder indicator should be, the range of mine currently is 0 to 100 Ohms and at present is only operating the lower Steering position guage (with a full set of...
As previously said check out that you are getting diesel to your injectors By disconnecting the feed pipe to the nearest one to the pump, and if so work on to the next etc. Also I would think that You should hear some diesel returning back into your tank from the bypass system if your pump...
Hi! Given that I haven`t climbed into my lazarette as yet to attempt to bleed my hydraulic steering (or to pump it up) is there anywhere that I can obtain the written method for carrying this out, ie how many turns each way of the wheel etc, and which nipple (I guess the top one first) I release...
Can anybody please give me the alternative part number for the replacement filter cartridge for this model of Separ Water separator
Thanks in anticipation, Rob
Hi, I have lost the feed to the eyeball spots in the main saloon (8 no, old type eyeball spots with 12 volt dc lamps) and the power feed to the 3 flourescents on the underside of the aft deck area which appear to be 24vdc. I don`t really want to change the spots yet for Led`s but of course may...
would any kind member of this forum have a copy of the manual for the above mentioned gearbox, that we could purchase, borrow etc.
Thanks in anticipation
kind regards
Rob!
would any kind member of this forum have a copy of the manual for the above mentioned gearbox, that we could purchase, borrow etc.
Thanks in anticipation
kind regards
Rob!
Lavac no water in
A hearty thankyou to all you guys, who replied to my post re the lack of water to a Lavac marine WC, and so quickly too. All the suggestions are very practical and one is possibly going to sort the problem I hope.
Thanks again
kind regards
Rob
Hi I am guessing that more than one of our member, will have had the same (or similar) problem with a Lavac toilet! the model is the plastic lidded, full sized pan model, about 20 plus years old! or more, its been maintained well by the previous owner of the vessel! and at present it builds up...