Pleinmont

Nice one! Many thanks... Just had a read... I remember the blown fuse/controller saga now!

Sorry for resurrecting a thread from the dead but I wondered if you ever ended up fitting the new Exalto controller to stop blowing...

That looks similar to the Roca. I 3D printed a mock of that motor and could not make it fit in the space, the shaft is on the wrong...

I need to act faster when someone gives me useful advice! I totally forgot about that helpful post from Jamie a couple years back...

I thought you already had a plan......

here is the link to the motor I bought (fitted and working) https://www.amazon.co.uk/dp/B0F662W15J?ref=ppx_yo2ov_dt_b_fed_asin_title...

Did some heat shrinking Tidied up the negative busbar. One shunt is for the house bank the other is for the engine battery (which will...

The original cable was still in pretty much perfect condition but I’ve re crimped everything anyway. Some big fat cables for the...

Waiting with baited breath to see if any of you lot manage to fit a new pantograph motor and wiper to a 760 and get it working. If so...

After much searching I found a replacement motor for the Doga! The one on the right I got from China via Amazon. There is one down side...

The rail comes in 3m lengths so it will have multiple joins anyway.

Perfect - sounds good!

Thanks - yes I was assuming/hoping that might be the case... A bit of care and attention cutting out the damaged rail and slotting in a...

I'm planning on refitting the rubbing strip shortly and I wondered if the aluminium backing rail could be fairly easy to replace whilst...

TAMD41 engines were still being made until 2005 I believe. My 760 built in 2005 has a 200hp TAMD41p and consumption appears to be about...