markc

Really pleased with this one - worked first time. The hoop on our Rocna anchor (this is the hoop that ensures that the anchor always...

Hello, Just coming back to this again. I've gone ahead and bought this boat and have them upgrading it to a 100hp Yam engine...

I'm assuming that the pipe that's left in situ is disconnected at both ends, so won't disintegrate over time... or leak, because nothing...

Hi Vas Yes I printed upright to ensure there was strength in the clip. If I printed flat I'm sure it would snap far too easily!

I can't see the problem leaving it in situ. Obviously, it would be better to remove it, but from.what I have seen, it would be a total...

I wouldn´t decide only by the model or make, condition of the individual vessel is probably the most important thing

My latest boat bit, a couple of clips to replace broken ones, created in FreeCad RC. Also, just designed a replacement radar screen...

Ok quick update The guide wire is through

Hey I converted my two heads to fresh-water and was glad I left the sea-cocks (recently renewed) capped and in place, I used one as a...

no 😆

Will do, lots of stuff arriving next few weeks so it should start to look more finished. I will post a few pics as it progresses.

Is it for a window? Clue please?

Window related? I've just got back from the boat with a bunch of things to design (in FreeCAD) and make for my next visit. Whilst there...

Is the existing hose butyl lined or the cheap white stuff? If the former, it would be better going down the unblocking route with acid...

Aha, I see. Interesting to hear of a shared ensuite for guest cabins, that's a layout I never came across. I suppose it's ensuite for...