Halo's latest activity

I had my Westerly at Uphill. I would have thought that you would be better off at a marina such as Portishead or Penarth. The Bristol...

I saw Concerto’s Fulmar on the way round and it seemed ideal to me. Don’t knock a bit of room and comfort on a long trip. Being able...

As far as I can see shore based foghorns are only going to be any good if the satellites are taken down. Anyone with a gps chip on a...

If it’s a a Vetus see through top strainer I would start with that. The top expands and shrinks a lot with temperature ( general issue...

Did a week long blokes charter in a new Grand Large 50 out of Gocek last year. Had a fine time. Did a run down to Marmaris and enjoyed...

Could it be fine wax particles? What happens if you warm some of it up to 60C does it go clear ? If so it may clear itself in summer...

People who run engines for no reason usually end up glazing their bores and then they make loads of stinky blue smoke. Heath hazard in...

When I came back to the boat a couple of weeks ago relative humidity was less than 30% despite being set to the thumbs up second highest...

Best use t’internet like we do in Yorkshire! If offshore is t’satellite !

I have been saying this for years on this forum. It's only a matter of time before somebody comes on and tells me that new boats are way...

Jaw dropping! Was it a two pot glue that they didn’t mix right?

I recall engines with wind up spring starts and the name of them starters will come to me at about 3 a m. ! There were diesel engines...

Mine has the cc over the joint. It also has several layers of epoxy under the cc including the joint area. No problem so far (8 years...

Good contribution from Yngmr but I would add that Raminol has much better water resistance and is better for some applications other...

Looks to me like either the washer is not stainless or there is water ingress into the bolt area above the washer that could be causing...