We did the scilly isles in ourTarga 39, made our way to Falmouth actually moored in Mylor.
Fueled up there and then over to Scilly Isle about 70m weather was kind .
Stayed 3 days in St Marys had to share swing moorings .
This was a new experience when the tide turns in St Mary bay the...
You can launch from Neptune car park in Herne bay the crafts have to be reqestured with Canterbury council check out There slipway web site
Think once registered they probide the code for the pad lock
It does dry out at low water .
Enjoy
Tiimbad
You require 4mm 3 core Blue Artic flex 32A amp rated , if cable runs are getting longer than 25m you require 6mm 3 core Blue Artic flex.( single phase supply )
Blue sheath is UK colour for 230v Yellow sheath colour normally indicated/ used 110v cable cores same size and rating but...
Best 30ft sports cruiser at era guessing its running KAD32, So should be good for 38k with clean bottom and stern gear.
Well made by Fairline, normally no major defects on hull or body work, fitout check window screen rubbers known to break down resulting in leaks to cabin.
Check below...
We had a similar issue with our 6m Rib obtained the yellow plastic gas pipe 150mm ish and used as rollers.
Jacked up the trailer removed the wheels lowered onto the pipe and run it into the garage , used jockey wheel to guide it.
Left it on the pipe work over winter, prevent flat stops on the...
Remove the spark plugs hand pull over to eject any water
and refill with oil and hand pull over to get the oil circulating the components plus small quantity in each cylinder via spark plug hole
Drain the fuel filter and carb remove air filter spray WD 40 to protect parts
Flush the engine with...
Follow the fuel pipes from the injectors back to the metering unit where they connect to metering unit/ injection pump
Its on the side of the engine if you activate your throttle control the bit that moves on the engine is where the rack is.
Engine would slightly lag behind the other engine under acceration RPM
They would be ballanced RPM upto 2900rpm the engine that had the fault on the metering unit / injector pump /rack
Would just hang at 2900-3000rpm
And not encease
Engineer who was trying to locate the
Problem was...
I had a similar issue but on a KAD42
Would'nt make revs went through
Normal fault diagnosis / testing
Replaced Turbo
No air leaks
Injectors serviced
Fuel and filters all fine everything looked fine and pressure where as they should be.
Last resort injector pump / unit had it serviced they...