Hello,
I have a Rule automatic bilge pump and I am looking for anyone who has experience of these pumps. I cannot remember the model I have but it is the type that does not require a float switch. Every 2.5 minutes the pump tests the presence of water. If none it switches off, but if water...
East Anglian wooden sloop.
I have looked through the solar threads but haven't found an answer to my question. I have stripped out my electrics ready for a complete re-wire. So I only have a Rule automatic bilge pump to keep out the water and to start the engine. If I get a 5 w solar panel...
The coaming on my wooden sloop has gone grey (from lack of attention). I can sand the wood back to a nice rich mahogony but is there a solution tht will do the job followed by varnish. Don't want to take off too much wood by sanding.
Any ideas?
Thank you. I knew it was there somewhere i just did't know where. It's my age you know.
Thanks for your replies. Looks like a replacement with the upgraded light is best, Sourced one as £35.
Thanks again
Posted a query about repairing a Plastimo hand held bearing compass v cheaper to buy a new one! But my post has vanished - or at least I cannot find it. Been away a few days so wasn't checking.
So, can these compasses be repaired or is a new one the best option?
Lookig forward to your replies
rgds
Which ever! I have one, a hand bearing compass with a permanent light. Trouble is the chamber now has a bubble in it and the light has gone out! Can they be repaired? or is it cheaper to buy a new compass?
All the best
John
Stop the rot
Cut out the rot and replace with a dutchman made from mahogoney (sp). Leave wood hardener to the furniture and other non-structural areas. As you remove the rotten wood you may well find that the rot actually goes further than you thought.
Good luck
John
A few days ago my Rule 1100 automatic bilge pump went peculiar. Instead of sampling every 2.5 minutes it began sampling every 12 - 15 seconds. The result was a flat battery. As I no longer had the receipt from the supplying chandler I contacted ITT(Jabsco) who asked me to send the pump to them...