I’m hearing horror stories regarding oil coolers. I’ve twin kamd44edc’s. I’m in the process of getting intercoolers cleaned and both oil coolers are getting replaced as there is signs of corrosion, as Bandit has mentioned. Expensive job but if the old ones fail it is curtains!
Hi, I hope someone can put my mind at rest. I have an Antares 1080 year 2003 with very low hours. She is powered by twin kamd44edc’s during a recent service I was advised that the oil coolers of this engine can leak oil causing obvious catastrophic failure as the sump contents empty into the...
I have a pair of these in on 2003 beneteau Antares. I have been warned there is a chance of oil cooler failure causing oil to be pumped into the bilge with obvious effect on the engine. Has this been an issue anyone has encountered?
Low hours on engines.
Cheers. And happy new decade !
I have had a slight issue with heating on my kamd44’s. I know the original water strainers are not great so I want to replace them. What is the best strainer to go for, see through kid ,and can I get a cast one with bottom outlet for application of antifreeze without removing pipes etc. 1.5”...
Hi, I hope i can be steered here to do the right thing. I believe reading forums that my heating problem on my kamd44’s is a partially blocked heat exchanger (both engines run too warm over 3000 rpm) can these be cleaned without removal as in my boat access to one of them is a massive job...
Hi, I hope i can be steered here to do the right thing. I believe reading forums that my heating problem on my kamd44’s is a partially blocked heat exchanger (both engines run too warm over 3000 rpm) can these be cleaned without removal as in my boat access to one of them is a massive job...
I have a beneteau 1080 with steam at 3000 rpm. The temp is running 85-90'. I am told it is normal. Dropping back to low speed temp drops to 60'. I have had new impellers fitted over the winter. I'm on. Shafts with exhausts above the waterline when cruising.
Hello.
I have a pair of kamd44 vp's in an Antares 1080. The guages for the temp show 85-90' when running st 3000 rpm the temp stays constant but I notice steam at the stern. Is this normal ? Many thanks,
Derek
Hi Paul,
you are exactly right regarding the negative isolation and the emergency switch which parallels all battery banks. My thoughts would be to have three separate batteries or battery banks which would isolate domestic from running. domestic being charged through a split charge relay and...
While checking the boat (beneteau Antares 1080) I noticed something which I think is strange with the original wiring of the batteries. There are three batteries as would be expected but two are wired in parallel. Not much start protection. Is this normal or just poor design ? What is the ideal...
Windy up here so a good chance to get a few jobs sorted. I am having a problem with a c95 which I have installed in the flybridge. Main display is a c127 which is connected to sounder,radar,ais etc and all works great. I have fitted the c95 using stng backbone cables. I reckon it should act as a...
I know this is a late reply but last year I fitted a bow thruster to my 1080. Great job made mooring a lot easier where I am on the tidal river Bann the flow can push you where you prefer not to go. (Vitus 25kgs) the windscreen washer bottle is in behind the circular inspection hatch under the...