Recent content by davidfox

Just to repeat my request, anyone got a Moody VaT receipt circa 1987 that I could look at can someone pm me?

Thanks to all for your replies and advice, anyone got a moody invoice circa 1987 so that I know what I am looking for..?

In process of selling and the prospective buyer wants to see the original Vat receipt from 1987 I have all the bills of sale back to the manufacturers, originals except the first which was a copy, hull certificate and builders certificate all originals, but no vat receipt from Moodys, my...

I didn't even know there were such things as 'yaw dampers' and computer controlled foils,,, but I watched the last race and prior to the start, Ben was talking the skipper through the start and he seemed to be pretty much laying down the law. Ben was v proactive in directing what was to happen...

Looking at the depth it wouldn't be on the East Coast then!

Extraordinary, read what he said!

The poster asked a perfectly sensible question and has received some good replies, I dont really think many of us are that interested in how big yours is compared to ours.

Mine is the smooth one, I was wondering if I could cut out the blisters and use the blisters themselves as patches after all they don't have holes in them, I didn't realize that they were PVC? do you know what the inner body of the floor comprises?

The current can run very fast, also the river trip boats are all over the place so you need to keep a good eye out, I would advise wearing a life jacket as any deck work is dodgy in the churned up water. Also don't lose your boat hook over side like I did just as I was attempting to pick up the...

This is a rephrase of a previous post, can anyone help with advice? The top and bottom 'skin' of the floor has sort of delaminated because of the heat forming large blisters from the escaping air any ideas on repair solution?

I left the inflatable floor fully inflated whilst the sun beat down on it and when I returned there was an enormous blister in both the top and bottom surfaces, it seemed that the high pressure bit had leaked into the surrounding skin and caused the blisters, I looked at a replacement and was...

I base it on water pressure, temperature control and space in the cubicle. Haven't been to Chatham and the tide mill wasn't much when I used them last but that was 3 years ago

That's about what I see, so all seems ok then!

Whenever I have checked the voltage on the batteries via a built in voltmeter it always registers over 14volts whilst it is charging does that sound good?