Looking at a picture of the motor from ebay could you not buy the replacement motor (assuming it has failed due to the stator windings) disassemble and change the rotor for yours?
You can get a small 56g pot of it off ebay for about £20. Comes with a brush easy that makes it far easier than Duralac to apply - just wipe brush around threads etc. Having said that I never had cleanup problems with Duralac either - just use trade wipes to remove excess. The only real problem...
Are you after a hard dinghy or inflatable? I have got a 9ft GRP dinghy with folding galvanised launching trolley with pneumatic wheels and a set of oars available if interested.
I have a complete set available comprising of:-
1. Display Unit + mounting bracket
2. Cover + spare
3. Pizeo alarm (never used)
4. New unused log transducer
5. Unused through hull fitting for log + blanking cap
6. New unused Depth transducer + extra cable
7. Spare o-rings for log
The display...
I had installed thick high quality plywood backing plates in 2010 on my U bolt lowers. Last season I noticed that they appeared to be lifting slightly from the deck so I pulled them to inspect properly. U bolts were fine but the plywood had slightly crushed over the years resulting in the gap...
I have done this method and as the splice beds in the thimble does become slightly looser - no where enough for it to fall out but with a bit of flexing I can subsequently remove the thimble which then allows me to remove the line from the stanchions for cleaning. I have thimbles on either end -...