penberth3

I think you've misunderstood 'halon replacement'.

To begin with , there are too many connections on the negative power stud As Andsarkit suggests replace it with a bus bar .

This is often the problem - the negative/return side. (Don't call it "earth" on here!!!) Carry on as Aurai said in Post #2...

Indeed, could this be another of those threads which start with something less than the full story?

I don't understand why you want an audible signal to basically let you know you've turned the key. I can't see the point, surely you can...

I think you're in a dream world, or experiencing the placebo effect. 6mm of foam left for weeks in winter will soon reach an equilibrium...

Which you should do anyway.

With the cost of some of them you could buy a new boat.

I've got some tiny cold chisels, 1/4" or less, which have been very useful. Could even be ground narrower if necessary.

Good advice, use a small welding nozzle, not the biggest cutting torch you can find!

Time, patience, lots of heat, PB blaster, a rubber mallet and a very thin hack saw eventually did the trick. I used the hacksaw around...

Warning - a lot of cutters and burrs described on E-bay as "Tungsten Carbide" are not Tungsten Carbide. Often the small print in the...

It was a proper Allen head from a Halfords professional kit..the grub screw was seized solid, I was being so careful that I was using a...

Don't they need to be around the bolt?