Where are Beta Marine engines made?

[Spirit (of Glenans)]

Thanks folks good to know. How do you check the anodes. Numpty question but it will be coming out of the water next week and probably going to be stored over the summer and through the winter. Should I do anything to it immediately e.g. Drain anything off and then winterise it. I just cannot remember, been a while since I had an inboard (only 7 years maybe but my memory is getting worse). Thanks. There maybe a chance of storing it for a couple of months and asking someone to sail it up from Torpoint to Chichester Harbour with and for me or just for me, so probably don,t want to winterise it just yet.

On the 11hp model that was in my previous boat the anode was accessed by undoing a (10mm?) bolt head on the side of the heat exchanger.
You should download the manual.

 

[Malish]

I had a Kubota based Nanni for many years (a 3.75HE as I recall), very neatly marinised and no anodes fitted, presumably because the materials chosen for the marinisation did not require one. Worth a though for a comparison, I would certainly buy again.