VP D2 40 con Sail Drive S130; no tracciona ni en avante ni en reversa.

[Fernando Lazcano]

Hello everyone; I am new to the community!

First of all, we have verified that the transmission from the crown of the SDrive to the propeller is correct.

Then we have disconnected the cable that goes from the morse to the selector; we manually put the selector forward with the engine off; then we turn it on and it pulls perfectly.

Next we turn off the engine and put in reverse, also manually and also in reverse it pulls perfect.

Now, when we first start the engine and THEN put forward or reverse directly from the selector, there is NO TRACTION whatsoever in both gears.

Our mechanic is now checking the module (see photos) investigating the cause ... we assume that the discs may be worn.

Any help, guidance or comment is appreciated

 

[BruceK]

Welcome to the forum. You have found the motorboat section and probably want to pose this question in
Practical Boat Owner's Reader to Reader
to reach the right audience. However I would concur. Sounds like the clutch plates are slipping.

 

[Fernando Lazcano]

[Content deleted]

 

[Moderator]

Clause 1 - Acceptance of terms
1.1	Use of the ybw.com Forum, including the private messaging service, indicates your acceptance of these Forum Terms & Conditions of Use as well as the Future Plc. terms and conditions (which can be found here) and any subsequent changes.
1.2	The YBW forum is an English language forum. Please conduct all interactions in English (by use of an online translation tool if required). Content submitted that is not in English will be removed as the majority of our users will not readily understand it, nor would our moderator and community admin team.

Terms and Conditions of Use