Varnish/Stains/Oil's

LONG_KEELER

Well-Known Member
Joined
21 Jul 2009
Messages
3,720
Location
East Coast
Visit site
Would be very interested on how fellow forumite's exterior wood is doing this season.

I have tried Danish Wood Oil on the toe rail with excellent results so far. Taken back to bare wood, then, about seven coats put on with a rag. Not very hard wearing, but very easy to apply again.

I wonder though if I have put too many coats on . It almost looks like varnish but has not gone too dark and is not sticky.

Any ideas on whether I should sand it back ?
 
Now using Sikkens Cetol Marine Natural. A bit orange but the "natural" does not darken the appearance

Tried many things in the past but this is the best so far.

Others have also suggested Sikkens Cetol Novatech + Novatop but according to the blurb it is not suitable for teak!
 
Danish Oil

Danish Oil contains a small amount of resin so is film forming unlike some other oils, teak for instance. This means the surface will cure to a relatively hard surface. There is a still a high content of oil to nourish the wood and give it a natural looking appearance. Putting 7 coats on means that you have built a fairly thick film of resin but also means the oil from later coats is not penetrating the wood. Normally best to put a couple of coats on with Danish Oil and top up as needed.
Unfortunately the name has been highjacked by plenty of cheap manufacturers and there is a vast difference in quality between them. Best to pay for an older name where quality (of resin and oil) has been maintained
 
I did all my brightwork with Deks Olje last year. The washboard, being vertical look great, but the topsides of the grabrails are starting to go. I attribute this to the extraordinary sunny spell earlier this year. Everything received five or more coats of D1 (penetrating oil) and then five coats of D2 ( drying oil). I believe the D2 is mostly Tung oil and dries to a pleasing gloss finish.

Planning to try refurbish this week - rub over with a coat of D1 to soften the existing finish and then a couple of coats of D2.

Rob.
 
Life's too short to mess about treating wood. Let it weather to a dignified silver-grey, and use your time and money more productively. :)
 
I used two varnishes on my two washboards as an experiment.
International and Le Tonkinois.
International was blistering and going yellow after two years, Le Tonkinois soldiers on looking reasonable after 5 years.

Wished I had known you used Le Tonk - I just bought a litre from Mr Murkin and had to pay £7 carriage. If we had bought a litre each and had them shipped together we could have saved on the carriage.
 
Top