nimrod1230
Well-Known Member
what are peoples thoughts and experiences with Torqeedo to replace a Mariner 3.3 which has died.
You didn't get the long-legged version by mistake? If not, approaching a beach there is a lever to lift which allows the leg to kick up. (You can't use reverse with this.) Also the weight of the battery gives a high fulcrum so it's easy to swing the leg of the motor up high where it automatically locks. A small lever releases it. But on a shelving pebbly beach paddling the last few yards would be wise.I bought a new Torqeedo 1103 which I haven't tried out yet.
I notice the leg is about 6" longer than the Yamaha 2b is used to have and I wonder if this is going to be a significant problem when using it on beaches or slipways. Should I be thinking of increasing the height of the transom? Or have Torqeedo ownwers not found it to be a significant problem?
I have what they call the standard version, which is the shortest.You didn't get the long-legged version by mistake? If not, approaching a beach there is a lever to lift which allows the leg to kick up. (You can't use reverse with this.) Also the weight of the battery gives a high fulcrum so it's easy to swing the leg of the motor up high where it automatically locks. A small lever releases it. But on a shelving pebbly beach paddling the last few yards would be wise.
. My only negative is that the noise of petrol made the children feel like there were going faster, the speed is the same...
The transom on my Achilles dinghy is 39cm (15.4") from top to bottom. From top to w/l will of course be less, depending on the load being carried (3-4" , I guess).The important measurement is from the top of the transom to the waterline, which on most dinghies is around 13-15" to take short shaft motors. A long shaft will be approx 6" longer so quite a visual difference.
I dread to think what Torqeedo propellers cost.
Ye Gods! I'll tell my wife she is to carry it like a baby.Unfortunately I can tell you that since my wife dropped ours off a trolley ... £99.
I had to raise the transom of my dinghy by a few centimeters. It made a huge difference, before I did the leg couldn’t rise high enough to beach her or to leave the beach, it also then drove better in the water. It was nothing but problems before I raised it then it ran perfectly until......I bought a new Torqeedo 1103 which I haven't tried out yet.
I notice the leg is about 6" longer than the Yamaha 2b is used to have and I wonder if this is going to be a significant problem when using it on beaches or slipways. Should I be thinking of increasing the height of the transom? Or have Torqeedo ownwers not found it to be a significant problem?
Thanks. That's useful information.I had to raise the transom of my dinghy by a few centimeters. It made a huge difference, before I did the leg couldn’t rise high enough to beach her or to leave the beach, it also then drove better in the water. It was nothing but problems before I raised it then it ran perfectly until......
one day it just stopped, error codes 45 and 30. We feared the worse, salt water ingress buggering up the battery as well. But, luckily it turned out to be the circuit board well above the waterline. €350 to fix and deliver. That’s the good news. The bad news is that Torqeedo Germany is having post covid supply problems. We were told one customer has to wait eight months for a new propeller. So we are trying to get a definitive answer before I get upset and have to drag the Honda 2.3 out of my workshop.
The real problem is that buying is easy but repair centers are very thin on the ground