Torqeedo 1003 error codes 45 and 30

[Bouba]

I didn’t realize that this was my thread !
Yes, I had the same error codes as you...and the diagnosis was bad...they said it usually means that water has got inside...but I was lucky

 

[Gianluca300]

Hi Gian, yes my Torqeedo was repaired...It stopped working and I had two error codes but I can’t remember if they are the same ones as you. I think I was lucky because when they first looked at it they said it cannot be repaired with those codes. But luckily it was dry inside. If seawater had got inside then it would be thrown away. All I remember is that they replaced the main circuit board, it cost about €350 just for the repair because I took it to the repair center myself....otherwise it would be another €100 for transport. This was about two years ago...all of the Torqeedos in the repair shop took a long time because they were short of every part.
I am sorry but that is all I remember

hello and thanks for the answer, in assistance they did not find water inside, but even replacing the pcb the same codes continue to appear .... hope to resolve soon ??thank you

 

[Bouba]

hello and thanks for the answer, in assistance they did not find water inside, but even replacing the pcb the same codes continue to appear .... hope to resolve soon ??thank you

Did the repair center test your torqeedo before they returned it?

 

[Gianluca300]

Did the repair center test your torqeedo before they returned it?

the engine is still serviced in Italy and I am awaiting a response from Germany regarding the problem that continues to give the same error codes e45 e30 even after replacing the pcb .... we hope to solve it soon

 

[Marranix]

the engine is still serviced in Italy and I am awaiting a response from Germany regarding the problem that continues to give the same error codes e45 e30 even after replacing the pcb .... we hope to solve it soon

Hi! I'm in the same your situation, same error codes same faulty behavior and I'm waiting to send the motor to the assistance. In my case the motor stopped working after a rope went inside the propeller, so probably the current spike have burned some insulation in the copper coils (but is only a hypothesis)
How much have you paid for the assistance? How much have you wait?

Thanks and ciao from Italy!