P Nut
New Member
Hi - I heard that Tollesbury Marina had been dredged fairly recently, does anyone have any recent experience of creek accessibility and marina depths? My boat draws 1.6m.
In addition to the good advice already, once in the marina and the level drops down to the cill some areas may dry out but the silt/mud so very soft and deep will not a problem for your keel. However, if you do settle into the silt ensure all your seacocks are shut as the silt is very runny and will otherwise get forced up into pipework but not run out again as the tide comes in.Hi - I heard that Tollesbury Marina had been dredged fairly recently, does anyone have any recent experience of creek accessibility and marina depths? My boat draws 1.6m.
Warning - Fred Drift!
Thought this might be an appropriate thread to ask whether anyone has any information on the ketch parked on the top of the seawall adjoining the Tollesbury North Channel? I noticed it on Wednesday as I was passing on the Blackwater, and it is still there today.

From experience of occasional visits to the marina shop, where the VHF was kept, there is seldom anyone there likely to have an operator's licence.Tollesbury alo seemed to have dispensed with monitoring Ch 80... not helpful when seeking confirmation that you pre-allocated berth is free (and wasn't... not good for yor average MAB with reversing 'challenges')
Seems to sum the place up at present, I just got the answerphone (at midday) I feel that support and maintenance of the marina is not high on the list of prioritiesFrom experience of occasional visits to the marina shop, where the VHF was kept, there is seldom anyone there likely to have an operator's licence.
There is decent mobile phone reception in the Leavings though
Update: We enjoyed our stay but didn’t read Plum’s advice about closing seacocks until after our visit. It turned out that the outlet for the fwd heads was blocked and I only managed to clear it on Friday in our home berth by donning the trunks and swimming under the boat equipped with a screwdriver and a wire coat hanger straightened out with a hook on the end. It took several ‘dives’ to clear it - pleased that we avoided the cost of a lift out but it wasn’t an easy job.
Surprised, would have thought an outlet would blast the mud out. Our toilet inlet was not usable while we were in there, but cleared by itself when we left. We were on hammerhead A by the fuel berth.Update: We enjoyed our stay but didn’t read Plum’s advice about closing seacocks until after our visit. It turned out that the outlet for the fwd heads was blocked and I only managed to clear it on Friday in our home berth by donning the trunks and swimming under the boat equipped with a screwdriver and a wire coat hanger straightened out with a hook on the end. It took several ‘dives’ to clear it - pleased that we avoided the cost of a lift out but it wasn’t an easy job.
Surprised, would have thought an outlet would blast the mud out. Our toilet inlet was not usable while we were in there, but cleared by itself when we left. We were on hammerhead A by the fuel berth.