Tip needed for sawing marine ply

G

Guest

Guest
Can anyone tell me how to hand saw marine ply without the bottom layer of the ply tending to splinter, specially when sawing across the grain? There must be a knack. Any help would be much appreciated.
 
G

Guest

Guest
cut/mark the underside with a 'stanley' knife first or use a tennon saw at a much lower 'angle' to the surface
 

PuffTheMagicDragon

Active member
Joined
16 May 2001
Messages
14,406
Visit site
Scoring on lower face with Stanley knife certainly works but might not always be possible. Tape is easier and almost quite as good.
IMHO the most important thing is to use a reputable saw that has teeth which are well sharpened and set. I use a Spear & Jackson but I'm sure that there are others just as good.
The idea is that the teeth actually CUT the fibres rather than TEAR them out - which is what causes splintering.

Wally
 

oldharry

Well-known member
Joined
30 May 2001
Messages
9,940
Location
North from the Nab about 10 miles
Visit site
Marine (and other) plys tend to have a very low moisture content and the veneers shatter very easily even with a decently sharp saw. The only sure way to get a clean cut is to clamp it to a piece of softwood along the line of the cut, which supports the surface of the ply and prevents splinters from being lifted out..
 

srp

Well-known member
Joined
10 May 2006
Messages
4,580
Location
Barnard Castle, Durham
Visit site
If you're using hand tools then there isn't a way of guaranteeing a splinter free cut, unless you fix a backing board to your sheet (and even then you get splintering because the chances are you won't be able to clamp it securely along the whole length of the cut). A knife cut on the underside seldom works because you can't see it while you cut.
The only way I know is to use a decent tracksaw (Festool or Mafell) for straight cuts, and for curved cuts a decent jigsaw with a sacrificial blade insert. Or a router with a combination upcut/downcut spiral carbide bit.
 

rhumlady

New member
Joined
3 Dec 2004
Messages
870
Location
Dumbarton
Visit site
Tape doesn't always work as the ply can come away when you remove it:( I use a Fatmax jetcut saw at a shallow angle or score the underside the cut a couple of mm away from the line and clean up with a router which is my preferred way.
 
Top