Technisat ST and Thompson tv

Maritimeman1664

Active Member
Joined
8 May 2020
Messages
57
Visit site
Hi folks just purchased a Sunseeker Mustique 42 and we were lucky to have installed a Thompson tv and technisat ST 3002 or 2003 receiver
I can’t seem to tune it any audio gurus here who can help ?
Thx
 
Check the co-ax to the antenna. It sounds like this may be a DIY job and for sure there is going to be a co-ax extension somewhere along the route. I installed an antenna and ran the cabling down inside the radar arch. The BNC connector to the external antenna absorbed water like a sponge around the shielding. Lasted a year. Redid it but sealed the connector this time and no problems since. My house exactly the same issue, fixed that and then one of the kid's rabbit decided to eat the co-ax. It is my destiny to always lose this fight. I dont watch tv, the kids have been weaned off it abruptly.
 
Check the co-ax to the antenna. It sounds like this may be a DIY job and for sure there is going to be a co-ax extension somewhere along the route. I installed an antenna and ran the cabling down inside the radar arch. The BNC connector to the external antenna absorbed water like a sponge around the shielding. Lasted a year. Redid it but sealed the connector this time and no problems since. My house exactly the same issue, fixed that and then one of the kid's rabbit decided to eat the co-ax. It is my destiny to always lose this fight. I dont watch tv, the kids have been weaned off it abruptly.
Yes I think I’ll pull the tv out and see where the cable goes I will take some pics and post851505D7-7C3E-437A-AC6B-53ACE2CEC07D.jpeg
 

Attachments

  • 3F6784FE-14DD-41DF-B6A2-BF220B8F3545.jpeg
    3F6784FE-14DD-41DF-B6A2-BF220B8F3545.jpeg
    15 KB · Views: 8
Top