T pieces for heater fuel supply

[Trevethan]

Trying to source a T piece to splice webasto heater into supply for Dickinsons stove.

Think I need 2 10mm ends and then a 4 mm connection for webasto.

Tried auto and plumbers merchants no luck, Tried ASAP too

Any suggestions?


Thanks!

Nick

 

[mainmarine]

the easiest way to proceed is with a 10mm equal tee, then reduce one branch to 4mm with reducer to suit.
Malc
Mainmarine

 

[stephenh]

You would be lucky to do this with one fitting.
Try a 10 x 10 x 10 tee and reduce down.
You might have to use an imperial fitting in between - e.g. 10mm x 1/4" and then 1/4" x 4mm or you might be lucky with, say, 10 x 6 and 6 x 4mm reducers.
Anyway try BES Ltd on Google.
Or try "plumbing reducer"

Good luck - if you are ordering online, make sure you get your male / female bits right !!!

Hope this helps

 

[DavidGrieves]

Hi

You could try here:-

http://www.rthursby.co.uk/


They have all the fuel lines, fittings, ducting, exhausts, skin fittings etc for Eberspacher. Might be the same as Webasto.

Dave