earlybird
Well-Known Member
The TP300CX was made by Navico. I have one. Simrad took Navico over and changed the name and perhaps the colour(?), but little else AFAIK.
?Simrad TP10 Tillerpilot Remote Control
- Thread starter Andrew_Trayfoot
- Start date
jensrisskov
New Member
It is possible to fit a wireless control into the casing of a Simrad 10 (and others) Tiller Pilot.
See here a how to do:
https://slowfoxsailing.blogspot.com/
See here a how to do:
https://slowfoxsailing.blogspot.com/
PabloPicasso
Well-Known Member
A broom handle with a short peice of dowel drilled and glued at right angles near the end.
Then you can reach the buttons from your comfy seat.
Thats not nmea 2000, perhaps nmea 1750 or 1800....
Then you can reach the buttons from your comfy seat.
Thats not nmea 2000, perhaps nmea 1750 or 1800....
greeny
Well-Known Member
A how to - add wireless remote to Simrad tillerpilot
I did this and it works just fine. No problems after 2 years use.
This is what you need. 12v 4ch Channel 100m Wireless Remote Control Relay Switch Transceiver for sale online | eBay Physical measurements of the relay board are important. Measure space available inside the tp10 before buying.
I did this and it works just fine. No problems after 2 years use.
This is what you need. 12v 4ch Channel 100m Wireless Remote Control Relay Switch Transceiver for sale online | eBay Physical measurements of the relay board are important. Measure space available inside the tp10 before buying.