2copplane
Member
My mate has a old furlex genoa reefing system on a 34ft sloop which works well except the swivel is very stiff. He's tried umpteen different lubricants and ways of cleaning it out but to no avail. It was previously stood for 10years unused. The unit nor manual give any hint to a model or age.
Furlex have advised the swivel should not be taken apart and self service but I'm hoping one or two forumites have experience (good or bad). My suspicion is the biggest challenge is fitting all the bearing back in, but I'd have thought some thick lubricant could act as a temporary glue.
Also any tips on removal while the mast is up? It looks like the bottom eye is a Norse type fitting that can be seperated and the furling unit then swivel could be slid off the bottom.
Furlex have advised the swivel should not be taken apart and self service but I'm hoping one or two forumites have experience (good or bad). My suspicion is the biggest challenge is fitting all the bearing back in, but I'd have thought some thick lubricant could act as a temporary glue.
Also any tips on removal while the mast is up? It looks like the bottom eye is a Norse type fitting that can be seperated and the furling unit then swivel could be slid off the bottom.