PRINCESS V39 drive Trim Problem - Volvo Penta

[Damian Casapinta]

Hi, I own a Princess V39, 2014 model.
I am encountering a problem with my Volvo Drives.
Both drives are fully done at -6.
Port drive shows an alarm and Trim monitor displays wrongly that Port drive is in breach position and monitor shows a reading 56 whilst the drive is down.
Port Drive does not lift or lower from the helm. Only STB drive moves.
Tried replacing trim sensor but problem persists.
Tried trim calibration reset but problem persists.
Tried switching PCU and EVC module but problem persists.
Anybody encountering this problem ?

 

[AllanG]

Hi,

As this is a motorboat problem, I would suggest you post this enquiry on the YBW Motor Boat site, where you may get some responses:-

http://www.ybw.com/forums/forumdisplay.php?14-Motor-Boat-Forum

 

[Momac]

Check for an in line fuse for the port drive trim pump. If the fuse has blown it could indicate some underlying fault.
I think the legs will have a tie bar between them and you shouldn't move one a great deal relative to the other. May be the inactive trim pump is messing up the electrics .

 

[Damian Casapinta]

ok thanks

 

[Damian Casapinta]

yes drives have a bar connecting them but drives can still be operated either manually or in sinc. fuse has been checked and is working.