perkins control panel

[gordonm]

NEW ON HERE ,BUT NEED A PERKINS CONTROL PANEL. 4 GAUGE MODEL WITH THE START STOP BUTTONS IN BOTTOM RIGHT CORNER. ENGINE IS A M225TI.
THANKS ALL....LOOKING FORWARD TO BEING A MEMBER.

 

[Firefly625]

Good engine... I got one.. and a panel, but rather attached to both. Welcome anyway!

 

[rogerthebodger]

NEW ON HERE ,BUT NEED A PERKINS CONTROL PANEL. 4 GAUGE MODEL WITH THE START STOP BUTTONS IN BOTTOM RIGHT CORNER. ENGINE IS A M225TI.
THANKS ALL....LOOKING FORWARD TO BEING A MEMBER.

Several here

You are being redirected...

Relatively easy to make one using VDO gauges and a plastic or aluminum made by a local panel engraving company

 

[gordonm]

sourcing the pcb that sits on the tacho will be the problem.... thats the bit that i need , I have all the guages etc just a blown pcb.

 

[gordonm]

Good engine... I got one.. and a panel, but rather attached to both. Welcome anyway!

We run a Lochin 33 on charter fishing and have two of these fitted. need the pcb that sits on tach.this has blown on the port side. other than that I seem to be rather attatched to mine also !! regards.

 

[rogerthebodger]

sourcing the pcb that sits on the tacho will be the problem.... thats the bit that i need , I have all the guages etc just a blown pcb.

Unless its a multi layer PCB its probably repairable.

Mine are hand wired anyway except maybe some of the indicator lights.

Post a pick of the front of the panel and the PCB track side if possible.

 

[gordonm]

I will try to do that as soon as poss.... its refitted to the boat at min as its only the tach and oil that not working,but we need the panel to start the engine ! We are working this weekend but will remove it again next week and poat pics.

many thanks.