P/Bracket leak

[Head]

I own a Jeannneau Merry Fisher 925 Twine engein which has a leak around the starboad P/Bracket at first it was thought to be the bonding between the hull and inner tray had fail but a hole has been drilled in the tray and the lamanating seem to have failed in the tray itself. Another hole has been drill into the reinforceing strut at the rear of the P/Bracket reinforcing box a camera placed through into the strut then a jack placed under the P/Bracket and the P/Bracket will push into the hull 5mm there do's not seem to be a move ment or crack in the bonding but stress cracks and move ment of to P/Bracket reinforcing box. A clear gape can be seen in the tray itself.

HELP Head

 

[capsco]

How old is the boat, did you buy it new, has it suffered impact damage?

 

[Head]

Hi Capsco

Thanks for your reply the boat was new 01/2005 I did not buy it new. On the 28/04/2011 I hit somethink. I was in over a 100ft of water. I shut down and after cheacking for taking on water and found none restarted had a videration on the starboard prop which cleared and I thought it must of been rope (rope cutter are fitted). Weeks later small amounts of water started to come in and slowly got increased This water only came into the Eng./Room when I come down off the plane. WE lifted the boat out three times and we could not see anything. I then asked a the loacal boat repear owner the do sea trials whith me (he also looked at the boat on two of the lifts) he removed the cover from the ruder houseing and water poured in this is a short answer to what happend