Opacmare Cockpit Sliding Door. Princess 50/3

[J12345T]

Hi All,

Just wondering if anyone knows how (or if it's possible) to adjust the runner heights on said door? It is a heavy double sliding (triple panel) stainless unit that doesn't sit square to the frame. By that I mean that the closing jam has a 1/4 inch gap at the bottom when closed.

Ideally, I'd like to adjust the jam side roller up (or vice versa) to make the jam and the frame parallel.

Many thanks.

James.

 

[bluejasper2]

Hi All,

Just wondering if anyone knows how (or if it's possible) to adjust the runner heights on said door? It is a heavy double sliding (triple panel) stainless unit that doesn't sit square to the frame. By that I mean that the closing jam has a 1/4 inch gap at the bottom when closed.

Ideally, I'd like to adjust the jam side roller up (or vice versa) to make the jam and the frame parallel.

Many thanks.

James.

HI JAMES at botom edge of doors there should be an access hole to adjust the height of the door either hex key or star key this adjusts the wheels on which the doors run on , there should be adjustment points at both sides of each door, hope this helps

 

[Seastoke]

HI JAMES at botom edge of doors there should be an access hole to adjust the height of the door either hex key or star key this adjusts the wheels on which the doors run on , there should be adjustment points at both sides of each door, hope this helps

It could be a Philips, it is on mine