nickfabbri
Well-Known Member
can anyoneone ofer suggerstions . I have a marine engine panel with the key snapped off in the ignition. Any idea how to get it out or do i have to buy a new lock. I have already tried with fine tweezers and no joy
ny key broke
- Thread starter nickfabbri
- Start date
Twister_Ken
Well-Known Member
Remove panel. Poke it out from the back???
Marine ignition locks are not usually very sophisticated - the sort of things that were being fitted in cars 40 years ago.
Marine ignition locks are not usually very sophisticated - the sort of things that were being fitted in cars 40 years ago.
MoodySabre
Well-Known Member
I had this happen with a car key. Blob of super glue on the end and poke it back in, count to 30 and pull gently (whilst holding breath that you haven't stuck the whole thing up). Worked for me.
michael_w
Well-Known Member
Dremel a slot for a stubby screwdriver and never have to worry about keys again!
Gin
Well-Known Member
If it is not a non-ferrous key, how about a strong magnet?
I had a similar thing last season and had already partly dismantled the panel, ready to short out the circuit when I discovered that a tiny jewellers screwdriver could actually just flip the broken blade out as the switch itself was old and worn.
Could you be so lucky too?
I had a similar thing last season and had already partly dismantled the panel, ready to short out the circuit when I discovered that a tiny jewellers screwdriver could actually just flip the broken blade out as the switch itself was old and worn.
Could you be so lucky too?
landlockedpirate
Well-Known Member
Super glue trick worked on a mastercraft key. As mentioned above, steady hand and gently gently approach.
Mark
Mark
Duncantaz
Active Member
A trick I have used with snapped keys in furniture is to lever it out using two notice board pins (the ones with the coloured plastic tops). They need to be very sharp.
RobinA
Member
Take the the whole mechanism down to your local locksmith - mine was Timpsons. They have very fine tools that they slide or twist in beside the key and then pull it out. Its very clever, but I left mine for 18 months (using the stubby screwdriver instead) only to discover the key had rusted in - so next time I shall be straight down to the locksmiths.
fireball
Well-Known Member
How much did he charge? We tried to get some boat keys from him, but because they were "non-standard" he'd have to order them in, minimum qty was 2 and wouldn't guarentee that they'd work ... oh - and that'd be a tenner please. .... bother that - SWMBO went to Southampton and got a single key for <£5 with the promise that if it doesn't fit properly bring it back and he'd have another go ....
As for getting the key out of a lock - I managed to snap off my key in the washboard ... just took the lock apart ... didn't take 10 minutes ... took 20 to put it all back again though!!
As for getting the key out of a lock - I managed to snap off my key in the washboard ... just took the lock apart ... didn't take 10 minutes ... took 20 to put it all back again though!!
