more eber woes

[ChattingLil]

My beautifully functioning eber has gone on the blink again after someone lounging in the cockpit snuggled up against the air inlet. After a couple of minutes it conked out and now wont start on 'heat'. It works on 'vent'. Any tips on what I need to do to remedy this?
thanks gurus.

 

[sailorman]

My beautifully functioning eber has gone on the blink again after someone lounging in the cockpit snuggled up against the air inlet. After a couple of minutes it conked out and now wont start on 'heat'. It works on 'vent'. Any tips on what I need to do to remedy this?
thanks gurus.

try the "Re-set" button it might be lurking under a black neoprene disc, press the disc
fingers x

 

[pcatterall]

What model? Stopping up the air intake may stop the eber but once cleared it should start again f it was a hot air vent then the heater may have stopped in over heat mode but should still restart.
Try disconnecting all power from the heater for a minute to let the ECU reset.
If the heater is a D2 and the fan starts immediatly at medium revs then that is common with D2 ECUs going on the blink.

 

[ChattingLil]

try the "Re-set" button it might be lurking under a black neoprene disc, press the disc
fingers x

ah yes. Got out the manual. Looked up 'reset'. Found where it was. Pressed it. Started up and ran perfectly! ta dah!

 

[sailorman]

ah yes. Got out the manual. Looked up 'reset'. Found where it was. Pressed it. Started up and ran perfectly! ta dah!

wots the deffo of an ex spert

 

[PabloPicasso]

wots the deffo of an ex spert

'X' is an unknown quantity and a spert is a drip under pressure