jw_2000_uk
Well-Known Member
Hi, my p bracket was bent, and eating cuttless bearings.
So I finally got around to removing it.
Questions,
1. I'm looking at a laser level on a stand to re-install. Is this the way to go?
2. It was sealed in a box, I'm not 100% on what material it was, any ideas?
So I finally got around to removing it.
Questions,
1. I'm looking at a laser level on a stand to re-install. Is this the way to go?
2. It was sealed in a box, I'm not 100% on what material it was, any ideas?
