KAMD300 Injectors Bosch part#

  • Thread starter Thread starter A_8
  • Start date Start date
A_8

A_8

Well-Known Member
Joined
28 Aug 2005
Messages
764
Location
Gothenburg
Visit site
I think this has been discussed but searching the forum does not give me anything. The VP sourced injectors are very expensive these days and I think they are Bosch which would make it likely they can be ordered as a Bosch, car or truck part.

Anyone know and what bosch part number they would be?

Google gets me ebay and a few others as BOSCH 0432191684 but that refers to the VP part for the KAD43/42 even though it says it's for KAD300. I though the injectors for the 300 are different .
 
A_8 said:
I think this has been discussed but searching the forum does not give me anything. The VP sourced injectors are very expensive these days and I think they are Bosch which would make it likely they can be ordered as a Bosch, car or truck part.

Anyone know and what bosch part number they would be?

Google gets me ebay and a few others as BOSCH 0432191684 but that refers to the VP part for the KAD43/42 even though it says it's for KAD300. I though the injectors for the 300 are different .
Click to expand...
It's all specified in the Technical Data manual....

KAMD300-A, KAD300-A
Injector holder, make and type
cylinder 1 ........................................................................... Bosch KBAL 75 P92
cylinders 2- 6 ..................................................................... Bosch KBAL 75 P77
Holder, marked
cylinder 1 ........................................................................... 526
cylinders 2- 6 ..................................................................... 527
Injector, type......................................................................... DSLA 140P 1145
No. of holes x hole size .................................................... 5 x 0.308 mm (0.012125")
Marked ............................................................................... 1145
Opening pressure
first stage .......................................................................... 24.0–25.4 MPa (3480.9–3683.9 psi)
second stage ..................................................................... 38.0–39.8 MPa (5511.4–5772.5 psi)
 
Thanks petem, I wonder why #1 is different than the rest.

Googling these type numbers do not get me any to purchase, I will try calling a Bosch workshop.
 
A_8 said:
Very helpful or not. If I knew what manual you refer to do you really think I would have asked.
Click to expand...
In the link that Googler has supplied there's a manual called the "Fuel System EDC". That's the one that explains how these engines work and gives some good diagnosis tips too. It also describes the function of the "Needle Life Sensor".
 
You must log in or register to reply here.

Share this page

Top