boatone
Well-Known Member
Someone asked on another thread how the Jubilee River operates for flood relief.
I have managed to find some info which I interpret as best I can.
The JR leaves the river above Boulters Lock and follows fairly closely just south of the M4 ( you can see it from the westbound carriageway as you approach the Windsor junction) before dropping south to rejoin the river just above Black Potts Viaduct at Datchet - see map below.
The diagram shows the relationship between the river level and the operation of the JR in flood conditions.
I believe the figures may have been revised since this data was published in November 2005 but basically the JR relief starts operating when the flow at Maidenhead Bridge reaches 180cumecs and, as flows increase the JR is adjusted via the Taplow sluices to take the excess maintaining the main river at 180cumecs until the JR flow reaches its maximum capacity of 145cumecs (this has, I believe been increased slightly but the aim is to not permit the JR to rise above 300mm below bankside). The JR is then maintained at that maximum level and any further increase in total flow is carried by the main river.
The Taplow Sluices appear to be operated in 8 stages, stage 8 being maximum flow and 0 being fully closed.
I have managed to find some info which I interpret as best I can.
The JR leaves the river above Boulters Lock and follows fairly closely just south of the M4 ( you can see it from the westbound carriageway as you approach the Windsor junction) before dropping south to rejoin the river just above Black Potts Viaduct at Datchet - see map below.
The diagram shows the relationship between the river level and the operation of the JR in flood conditions.
I believe the figures may have been revised since this data was published in November 2005 but basically the JR relief starts operating when the flow at Maidenhead Bridge reaches 180cumecs and, as flows increase the JR is adjusted via the Taplow sluices to take the excess maintaining the main river at 180cumecs until the JR flow reaches its maximum capacity of 145cumecs (this has, I believe been increased slightly but the aim is to not permit the JR to rise above 300mm below bankside). The JR is then maintained at that maximum level and any further increase in total flow is carried by the main river.
The Taplow Sluices appear to be operated in 8 stages, stage 8 being maximum flow and 0 being fully closed.