Flybridge Screen For a Princess 388

N

nav1

Member
Joined
13 Aug 2012
Messages
41
Location
London
Visit site
Hi all,

can any advise where i could get a replacement flybridge screen made for a 1990 Princess 388 - the original is fine, just the typical brown and i would like to replace it with an alternate blue colour

many thanks
Paul
 
sales@littleportboathaven.co.uk

paul@thefrazerco.com

There are lots of perspex people about. Flat panels are not too bad, but as they get curved the bill goes up.

I was quoted £4500 by little port above ( squadron 58 - there might be a bit more perspex but the curved part costs and will be similar is in size).

Location might also be a consideration as you need to get them off and to them to copy - googling local perspex fabricators would be my suggestion.

You might find someone who has the templates if they have made them before. I don't know if there is a dedicated princess forum somewhere where you have a chance of finding someone who has had it done for your boat. Also princess seem to have a department that sources old parts ( Fairline take note) and they maybe able to source for you
 
Similar cost for mine jrudge (P385 - older version of the P388) as the Perspex is not pre-curved before fitting. The curve is very gentle on these, so a flat piece is cut and bent around the stainless fitting securing it in place.

My issue was the length - the original is one piece, so they had to buy in stock of the colour I wanted as standard length sheets are about 300mm shorter than the screen! Still got most of a large sheet of lightly smoked grey if anyone wants a bit...
 
guys thank you so much, have contacted fibresports and they will respond tomorrow - thank you for your great hep!!
Paul
 
You must log in or register to reply here.

Share this page

Top