[2574]
...
This is a long shot - does anyone on here have a Flexofold propellor puller tool that I could borrow or buy? I can get one shipped from Denmark but that'll take time, if there was one in the UK that would be extremely handy.
Flexofold puller please?
- Thread starter [2574]
- Start date
DinghyMan
Well-Known Member
2 or 3 bladed?
I think the smaller GORI style prop removers will also work for FlexoFold, same idea of put them under the pins and use a central bolt to remove the prop
Measurements I have for FlexoFold is 30mm wide bar and "wings" which is same width as GORI removers
Alternative is a piece of 30mm x 20mm bar with a threaded hole through it
I think the smaller GORI style prop removers will also work for FlexoFold, same idea of put them under the pins and use a central bolt to remove the prop
Measurements I have for FlexoFold is 30mm wide bar and "wings" which is same width as GORI removers
Alternative is a piece of 30mm x 20mm bar with a threaded hole through it
[2574]
...
Three blade with 30mm wide blade root. Didn’t know the Gori puller would fit.
DinghyMan
Well-Known Member
Volvo 3 bladed puller - got a flatter version of the above, central hub is 45mm wide, wings are 25mm wide by 15mm thick, central 16mm HT bolt
[2574]
...
Ooooh.....that might work. Will send pm later.
MAURICE
Well-Known Member
interested in this as I had a heck of a job getting mine off. I had to use some heat a hammer and a puller that didn't quite fit
DinghyMan
Well-Known Member
The Volvo type puller above should work with the Flexofold props as the legs should fit between the hub and the retaining pins, just like the genuine puller
Other threads that may be of interest
