Electric Cable Identification

[maxi77]

I use plastic labels you write on with permanent marker (fine) that have an integral cable tie. Can be fitted at any time and even changed if needed

 

[PetiteFleur]

Just about any of the Brother label printers will do this sort of job and make nice labels for a switch panel.

Make sure you get the correct printer which can use the UV resistant tape, which lasts a long time exposed - the usual type of label is not readable after a year outside!

 

[prv]

Make sure you get the correct printer which can use the UV resistant tape, which lasts a long time exposed - the usual type of label is not readable after a year outside!

Fortunately my wiring is generally not just inside, but sealed up behind access panels and internal fitout

Pete

 

[Stork_III]

Make sure you get the correct printer which can use the UV resistant tape, which lasts a long time exposed - the usual type of label is not readable after a year outside![/QUOTE

I have used normal TZ tapes for labelling in the cockpit. All labels perfect after 4years.