ultrarep
Well-Known Member
Is there a way to set the shift delay on the EDC systems?
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
Edc question re shift delay setting
- Thread starter ultrarep
- Start date
aquatom
Well-Known Member
No.
[2068]
...
Is there a way to set the shift delay on the EDC systems?
Unhook the cables from the actuators, and send two children into the bilge with pliers and a VHF radio.
Pliers are applied to shift cable, and ...
... "Pull" is forwards (I think).
You might laugh, but this is pretty much the emergency shift procedure from the manual in the case of actuator failure!
ultrarep
Well-Known Member
Ok thatnks all just thought that I read that it was adjustable. As for the second idea got the pliers but the kids could be an issue as the living acom between the 75's is not well equipped. Also getting a VHF course is for the opperators and ptoper H&S training on pliers use wiv a youf puts the cost out of reach!