Eberspacher KD2000 software anyone?

[ean_p]

Hi
Does anyone one know where I could obtain a copy of the Eberspacher KD2000 software which i think it is possible to use with a laptop to reset Hydronic heater lockout etc.
many thanks for any info

best regards

Ian P.
ianp@ianp.karoo.co.uk

 

[bdsweeting]

Found a bit of info here...
http://www.espar.com/pdfs/
check out access.pdf they talk about a diagnostic tool and wiring diagrams; it may be of help.

Also
diagnosticinstruction.pdf

The warranty manual on page 49 gives the software version
http://www.espar.com/pdfs/warranty_manual.pdf

If all else fails you could try them...

 

[David2452]

I have a copy on CD, but you need a black (well kind of dirty grey) box as well.

David

 

[ean_p]

Thanks for the info , it would seem from the info on your links Brian that the KD2000 is not compatable with the Hydronic 10 so looks like we'll have to go down the timer / diagnostic route.

many thanks

Ian p.

 

[Hoverx]

I have a copy on CD, but you need a black (well kind of dirty grey) box as well.

David

Hi
Does anyone one know where I could obtain a copy of the Eberspacher KD2000 software which i think it is possible to use with a laptop to reset Hydronic heater lockout etc.
many thanks for any info

best regards

Ian P.
ianp@ianp.karoo.co.uk

Hi,
Currently overhauling an 36 ft Rolland designed twin keel. An Eberspasher was installed in the past. Still have the loom, the controller and some of the ducts.
I have installed a used Airtronic D4 (Older than H-Kit). The heater does work. However I would like to check all parameters are right.
I'm after a compatible copy of EDITH or KD2000 software.
Many thanks for those willing to dig-up your disks and share.