tri39
Well-Known Member
Can someone remind me who supplies good adhesive"'Tender to" dinghy panels panels.
My new Honwave looks very nickable!!
My new Honwave looks very nickable!!
Dinghy panels
- Thread starter tri39
- Start date
Twister_Ken
Well-Known Member
So, the tender "Tender to Nickable" is on the dinghy pontoon. "Aha" thinks scrote "there's no one aboard Nickable. I'll just pop over there and relieve them of their electronics."
Seajet
...
Very true; my fathers' boat was broken into when she was the only boat on the moorings, he'd just bought her and the rest of the club had yet to launch.
Despite it being obvious the nreak-in was by lowlife amateurs rather than pro' thieves - they even cooked a meal and may have slept aboard - they were clued up enough to steal that boats' tender from the pen.
However most of us do use the 'Tender To', for a start if I didn't the berthing officer at my club would probably drop dead 'does not compute'...
Try SAC Graphics, I've used them a lot and they're very good; they do special stuff for inflatables, if you're lucky it may be available in reflective lettering as a safety measure, should you fancy it.
Their website has all the gen' re. measuring and font style, colours etc.
BarryH
Well-Known Member
EEK! Are you sure about the cost! A couple of quids worth of vinyl at most and 30 seconds at the PC.....
Seajet
...
Not everyone wants to look like a 'Blue Peter' prototype ! 
tri39
Well-Known Member
Thnx SeaJet.
BarryH
Well-Known Member
Not everyone wants to look like a 'Blue Peter' prototype !
Not saying that they do. But knowing how much a roll of vinyl costs me and how long it takes to set up the cutter and let it do its thing it seems expensive, maybe I'm too cheap......