Cummins 5.9 6bt rocker covers

D

Dick Atcherley

Well-Known Member
Joined
8 Jul 2014
Messages
102
Location
london
Visit site
I wanted to buy 12 of these to powder-coat, and swap over with the flaking, corroded rocker covers on my engines. Second-hand absolutely fine. I wondered if anyone had a ready source of these for not too much money? I could simply refinish the one's on my engines, but it just seemed simpler to change them over on an 'exchange' basis, rather than leaving uncovered rocker gear in a corrosive environment! They do crop up individually on Fleabay, but I really wanted a job lot...
 
Dick Atcherley said:
I wanted to buy 12 of these to powder-coat, and swap over with the flaking, corroded rocker covers on my engines. Second-hand absolutely fine. I wondered if anyone had a ready source of these for not too much money? I could simply refinish the one's on my engines, but it just seemed simpler to change them over on an 'exchange' basis, rather than leaving uncovered rocker gear in a corrosive environment! They do crop up individually on Fleabay, but I really wanted a job lot...
Click to expand...

Best place is a lorry breakers yard , if latestarter was on here I bet he has some.
 
Thanks a lot - good suggestions - any suggestions as to Lorry breakers yards? Haven't been to a breakers yard for 30 years since I used to run a TR6 off bits robbed from dead 2.5pi saloons in a breakers yard at Park Royal. Long since gone...
 
You must log in or register to reply here.

Share this page

Top