CT1 can be used

[rivonia]

Hello,
started a new thread so as to let the wider audience know. CT1 can be used to stick rubber to Gelcoat-Great.
Below is the reply from the manufacturers.

Peter


From: John Kilroy
Date: 10/07/2013 17:3
Subject: RE: CT1 important question


Hi Peter,


Thank you for your enquiry and sorry for the delay in response! In answer to your question CT1 will bond Rubber to Gelcoat. If you have any other queries don’t hesitate to call or email. Thanks



Regards,

John

IT Department



C-Tec N.I. Limited

Unit 6 Ashtree Enterprise Park,

Rathfriland Road,

Newry,

Co. Down,

Northern Ireland,

BT34 1BY.

www.ct1ltd.com

 

[vyv_cox]

Rubber? Highly unlikely to be rubber. Neoprene? nitrile? Perhaps even EPDM?

 

[rivonia]

Rubber? Highly unlikely to be rubber. Neoprene? nitrile? Perhaps even EPDM?

Hi Vyv,

You are more than likely correct. To me being just a simle person it is all rubber to me. I know I know as a yachtie I should know the difference but I don't.

Any way there you go.

Peter

 

[LadyInBed]

Regards,
John
IT Department

Good to see the IT Dept are product aware!

 

[savageseadog]

Let me know in a years time.....................

 

[dimdav]

Dont under estimate just how good this stuff is. I'm still blown away that it will cure under water or on wet surfaces, where it actually drives the water out of the joint while curing. I dont use anything else on the boat or home now.

 

[oldgit]

Used it to seal my P brackets to hull,seems a lot less messy that the opposition and cheaper too.