burgundyben
Well-Known Member
I don't know. Sorry.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
BMC diesel/ Parsons gearbox.
- Thread starter David Hiley
- Start date
bristoljim
Well-Known Member
Sorry still in dock - will come back when I canPossibly your motor was an automotive version whereas mine is definitely an industrial version, probably a tractor. Could this make a difference?
Jim
bristoljim
Well-Known Member
David - you have a PM JimHello Ben. Thanks for the info. Were your 4/98's automotive or industrial. That's where whoever did this insurance job screwed up. They thought yippie we'll stick this 4/98 in here then found the back of the block was different and bodgied it up. My engine has come out of a tractor or something and has substantial bolts holding the box to the block. There is no separate bellhousing on a tractor as far as I can ascertain. The gearbox bellhousing being cast in one piece and becoming, for all intents and pruposes, a structural part of the machine.
David Hiley
New Member
Sorry Jim I don't understand.
bristoljim
Well-Known Member
David - it is not normal to put email addresses on the public forum so I have sent you a private message (PM) with mine in it.Top of page RH side should have a red dot ! we will then be in simple email communication.What do all the lay shafts etc do?Sorry Jim I don't understand.
Jim