Bearing for a Jabsco raw water pump

[CalicoJack]

The engine is a Perkins 4108. I want to replace the bearing on the Jabsco raw water pump. I went to Kent Bearings and they could not match it. The numbers on the old bearing are RHP England then of course the crucial bit, which has a wear mark on it but could be 55D IS KDD.
The dimensions are outside diameter 35mm, shaft diameter 15.83mm and width 15.80mm.

Any thoughts on sourcing on of these?

Thanks

Nigel

 

[nigel1]

So thats a Jabsco 3270-200 pump.'
Jabsco part number for bearing is 92600-0070, listed at about £19 ++.
Jabsco site shows out of stock.
Could try ASAP listed at about £17 ++.

Sorry, cannot help with the numbering, a wild guess from your dimensions and looking at our bearing chart would indicate a base number of 5202.
The DD is probably for double rubber seals.
I found ASAP and Jabsco prices to be very close to bearing supplier prices, so try either one.
A new pump is going to be about £200

 

[omega2]

you could look here?

http://www.jabscoshop.com/marine/