nimrod1230
Well-Known Member
Well here goes. Cristec CPS2 60amp charger fitted as OEM. Worked well with both shore power and suitcase input. Yesterday, after running the generator for 4 hours the domestic battery voltage was lower than before I started. While pottering I had the heating on full blast. Before charging the batteries registered 12.6v. On charging the input showed 14.4v. I didn't check for a while and later the input voltage had dropped to 13.4v. Curious, I switched the charger off and on where the input was back to 14,4v for a few seconds and then down to 13.4v, I assumed ( wrongly as it turns out ) that the batteries were charged and the charger had reverted to float charge as in the past. Now, I am pretty useless with electics so any guidance as to possible causes and a starting point appreciated.