ChasB
Well-Known Member
I need to replace some portlights (aka windows). /forums/images/graemlins/frown.gif
Lots of messy black stuff on there. Pompanette recommends using Anti-Bond 2015. Any ideas on where I can get it?
Or is there another way to remove glue gunk without damaging the gelcoat?
Also... The seal that goes between interior trim ring and the spigot (am I using the right terms? /forums/images/graemlins/confused.gif ): What should I use? Where do I get it? Or would marine silicone sealant be good enough?
This is for fitting a portlight in this range:
Lots of messy black stuff on there. Pompanette recommends using Anti-Bond 2015. Any ideas on where I can get it?
Or is there another way to remove glue gunk without damaging the gelcoat?
Also... The seal that goes between interior trim ring and the spigot (am I using the right terms? /forums/images/graemlins/confused.gif ): What should I use? Where do I get it? Or would marine silicone sealant be good enough?
This is for fitting a portlight in this range: