Advice

[Neon]

Hi, could u help??? I have recently bought a Wilson Flyer 16' boat from a friend of a friend of mine, and for ages I have searched on the internet for clues to where the Wilson Flyer boat was made. Do you know where the boat was made, and if so do you know of any contact number/address that I could use to contact the manufacturer or even a supplier?

The other question that I have is, do you know where I could get a hold of a cabin for my Wilson Flyer 16' ??? At the moment the boat has no cabin on it and I would like one to be fitted. I am currently living in Plymouth, uk.

Any advice on these matters will be very much appreciated
thanks for spending the time to read this message

Rod

<hr width=100% size=1>

 

[Davy_S]

Hi Neon,
Welcome to the forum. It is quiet on here at the moment , but as no one else has answered here goes! THe Wilson Flyer used to be advertised in sea angler monthly, and i think it was made down south. You could buy all stages of mouldings from bare hull, or hull with glassed in stringers, hull and cabin bonded together or complete boat, the cabins were available seperately also. I have no copy of the mag at the moment so cannot give details sorry. If you wait until midweek i am sure someone will answer you rather better than my attempt! Good luck.

<hr width=100% size=1>

 

[Fingers]

Rod,

Not sure where the Wilson Flyer was made, however there are usually loads of advers for boats and accessories on the following sites.

www.boatsandoutboards.com
www.reesmarine.com

There is also a link to boat adverts from the autotrader web site.

I do recall seeing a cabin roof advertised for one a couple of weeks ago. There are rafts of these boats knocking about, so they seem to be pretty popular.

Sorry I cannot be of more help.

All the best.

Dave.

<hr width=100% size=1>Nil Illegitimi Carborundum!

 

[Kawasaki]

Neon,the current address for "Wilson Flyer" is 26 Scratchface lane, Bedhampton,Havant, Hants.PO9 3NG . Tele 0203 9247 3920. Don,t know a web sight for them but they are still trading and you will probably get all the bits you need from them.As Davy-S said the boat was supplied in various stages so a roof etc should be no problem.Get flying!

<hr width=100% size=1>50

 

[Neon]

Thanks for all ur help guys.

<hr width=100% size=1>