RunAgroundHard
Well-Known Member
Currently installing the Actisense NGW1 to STNG above headlining. I have connected it to the white connector on my SeaTalk NG to SeaTalk 1 Converter (E221581211118) and the red light on the Actisese is flashing. At the other end are the 5 bare wires (blue, white, black, red, bare). I am going to insulate the ends, complete running the cable under headlining and into the trunk.
The Actisense will be connected to the ICS Navtex 6 so that the rolling road, XTE, course details can be displayed down below. The cable is too short so I will button up all the panels again and refit the trunk cover until I can get the extension wire and connectors.
Question, if I use the Raymarine ST 60, ACU400 and Axiom+, with nothing connected to the end of the Actisense cables will that all work, or should I disconnect at the converter and refit the black terminator?
Thanks!
The Actisense will be connected to the ICS Navtex 6 so that the rolling road, XTE, course details can be displayed down below. The cable is too short so I will button up all the panels again and refit the trunk cover until I can get the extension wire and connectors.
Question, if I use the Raymarine ST 60, ACU400 and Axiom+, with nothing connected to the end of the Actisense cables will that all work, or should I disconnect at the converter and refit the black terminator?
Thanks!
