stephen_h
Active member
Hi,
I am having to replace some worn acetal rudder bearings - 60 OD x 40 ID approx.
Outside dimension not a problem since I can measure the ones I have removed but not
sure about the internal clearance needed between the stainless steel shaft and the bearing.
I don't want them binding due to expansion of the stainless steel or the acetal or if this is even a problem.
Anyone with any experiance of this??
I am having to replace some worn acetal rudder bearings - 60 OD x 40 ID approx.
Outside dimension not a problem since I can measure the ones I have removed but not
sure about the internal clearance needed between the stainless steel shaft and the bearing.
I don't want them binding due to expansion of the stainless steel or the acetal or if this is even a problem.
Anyone with any experiance of this??