webcraft's latest activity

The pump is below the waterline and before the bowl, so I don't see how this would allow me to dismantle the pump or rod the inlet.

Yes, seems so. I can shut it, but it is likely the blockage is at the seacock/through-hull Am considering the following procedure...

As I said in the OP, I can't completely shut the outlet seacock, so stripping the pump could get messy . . . Or can I remove it...

I thought that too, but the pressure is on the downstroke, not the upstroke.

Jabsco pumps out smoothly when lever in empty bowl position, but very stiff when pumping water in. Partially blocked inlet, or...

Still doing it. Any suggestions, apart from leaving it permanently on? — W

I have a starting problem with my Beta 16 which I have (apparently) fixred before by disconnecting and reseating the multiplug. This...

Bishop Skinner

I have 3rd party insurance all year round all European waters £160 - W

Correction. You made the gasket. My contribution was the coffee and moral support. Anyway, you're late for beer o'clock.

Here's a view of Stingo's wreck, taken after helping him make a carbhurettor gasket for his outboard this morning.

Thing is, it has never done it before. I left it switched on for 48 hours to charge up any internal battery, but when I switched it off...

Battery volts went up, so the charger is working. I completed charging with the solar, and soc is at 93%, but as the shunt did not...

It does show the battery volts, but that is not a very accurate way of calculating the soc

Probably, but the shunt should still show the soc of the battery and it didn't go up at all.