volvopaul's latest activity

Join it with a heat shrink crimp connector , that’s what we did on the modification engine end .

I enjoyed those two videos. It looks a reasonably modern set up. They are doing infusion, modular furniture construction, lots of CNC...

I have just fitted a new HCU to a D12 , order it programmed you will need the engine serial number and state if it’s port or starboard ...

All I seem to hear from MDL staff these days is how many staff they seem to turn over , I suppose there is nothing wrong by bettering...

Hose from the exhaust elbow is 5inch , not sure without an engine room photo if it routes to a lift silencer , if so it might exit at a...

Looking forward to part two

Many years back I fitted one to my Princess 410 , I fitted 2 batteries up front under the bed so was a very short cable run and used the...

.

OP unfortunately you have a specially made section there as it expands from 5 inch to the exit fitting in the hull, I would contact...

Hi Terry we hired a small day boat at Abingdon recently for 4 hours , got to Sandford and back in that time with a stop at the kings...

I doubt it is a fine, it will likely be an invoice dressed to look like a fine. There is a big difference.

I've just changed the clamps for new stainless ones, they were pretty badly corroded, but the hoses are OK. May have been a false...

Idle speed is too low at 600 , needs to be 625/650

The 63P should be on 5 inch hose , I use Vetus hose from Vitesse marine , any chance you can post a picture as rubber doesn’t actually...

Is he a block paver by day.