vas's latest activity
-
vas reacted to MapisM's post in the thread Victron Multiplus up and running, but... With a few BUTs! with
Like.
Ok, this is hopefully the last chapter of the saga. The main good news is that the last chapter is NOT the boat explosion, phew! 🥳 But... -
vas reacted to PaulRainbow's post in the thread Victron battery bank dead after just three seasons, any bright ideas? with Like.
If you don't do something you're not going to get anywhere. How have you jumped to the "duff battery" ? What charger settings are you...
-
vas reacted to geem's post in the thread Victron battery bank dead after just three seasons, any bright ideas? with Like.
Victron kit is programmable. There are recommendations on how to charge batteries by the manufacturers. Setting up the correct charging...
-
vas replied to the thread Victron battery bank dead after just three seasons, any bright ideas?.not particularly helpful tbh... 14.6kWh from shore (rather lot!) and 11.9kWh consumption? are you onboard? cooking, air-con heating?
-
vas reacted to MapisM's post in the thread Victron Multiplus up and running, but... With a few BUTs! with Like.
I didn't investigate all the components that you guys are referring to, but in my understanding, also the Multi equipped with the...
-
vas replied to the thread Victron battery bank dead after just three seasons, any bright ideas?.can we also have the system overview graph with the kWh for today? like this:
-
-
vas replied to the thread Victron battery bank dead after just three seasons, any bright ideas?.agree! to stop speculating, I think it's time to turn the multi to invert only mode, unplug from shore power just in case, and get the...
-
vas reacted to PaulRainbow's post in the thread Victron Multiplus up and running, but... With a few BUTs! with Like.
Similar to mine, Multi II (3000/24/70), MPPT, Smartshunt connected to a Cerbo and Touch 70. My Pi, from the previous boat, is in a box...
-
vas replied to the thread Victron Multiplus up and running, but... With a few BUTs!.Paul, I think, that was the issue with the old firmware multi, couldn't connect it to the Cerbo, RJ45 connector was there on the multi...
-
vas reacted to MagicalArmchair's post in the thread VP D2-55 - Raw water pump - refurb or replace? with Like.
Fair point, so after the long piece of wood with the mallet had driven the shaft down, on the sea water side, we had the below...
-
vas reacted to PaulRainbow's post in the thread Garmin Reactor 40 - use with non Garmin Pump with Like.
This obviously isn't a combination i have tried, but i did similar a couple of years back and ended up with the ECU 10, which i changed...
-
vas replied to the thread VP D2-55 - Raw water pump - refurb or replace?.maybe add a pic or two with the seal on the shaft, to make sure none fits it the wrong way round with the spring getting in the seawater...
-
vas reacted to geem's post in the thread Victron battery bank dead after just three seasons, any bright ideas? with Like.
In my experience with shunts and lead batteries, it's not easy keeping the shunt set such that it gives any meanngful results. I know a...
-
vas replied to the thread Victron battery bank dead after just three seasons, any bright ideas?.ok, nice setup similar to mine: bmv, mppt, multiII all connected to rpi running VenusOS, as well as a bms for the lifepo4 and the N2K...
-
vas reacted to GEM43's post in the thread Victron battery bank dead after just three seasons, any bright ideas? with Like.
No BMV, but SmartShunt via Bluetooth and VE Connect to a Cerbo (with screen) then up to VRM.
