vas's latest activity

surely that's with a NMEA0183 connection. got the blue plug one zillion pin and tiny cables and are you sure you use the right wires...

so looks like batteries were almost empty, there's no way the 97% is accurate if it's dumping 80A now :) push charge them, the counter...

55A load for fifteen minutes then load off, charger on results in:

Yes V and CCA and a declared “battery condition”.

not sure how you can restart the charge cycle, hence recommending a quick equalisation interrupted leaving them in bulk. OK, I know in...

how were they tested? with these el. testers that give a voltage and CCA rating? or manually?

Batteries have just been tested. One dead battery found in the bank of six. Now excluded from the bank and charging the remaining five...

wont work in your case I'm afraid, you'd need a newer h/w multi so that you can wire it using blah blah (don't remember the terminology)...

most likely is, there's no way bulk stops just like that while batteries are accepting 20A, only due to a timer! @GEM43 you need to...

look, it's pumping lots of amps for 8h! definitely batteries not full. As I said I'd do it again (interrupt an equalisation) and see how...

sorry, cannot claim that I remember what I did 3-4yrs ago! whatever tools I used (obvs recommended and downloaded from victron), I...

What is the charging profile for your AGMs? Does it match the Victron recommended settings? I assume you spend the vast majority of the...

As I was reading your last post, I started remembering going through versions of old/new h/w #, trying to figure out why I couldn't...

I'd see how long that takes, if it goes to the next stage (however it's called by Victron!) then i'd be tempted to start another...

I agree. I would also check what voltage they settle at when disconnected from charging sources and with 0A load. They should settle at...